6 points for attention in the design of steel structure workshop, the workshop can also be as warm as home

A good factory environment is very important for both the boss and the employees. Nowadays, there are more and more steel structure workshops, and people's requirements are getting higher and higher. So what should be paid attention to in the design of steel structure workshops? Light source steel structure workshops are generally relatively large, so lighting is very important. During the day, indoor lighting can be improved through skylights. When arranging lighting panels or lighting glass on the roof, consideration should be given to the use of skylights. The service life is coordinated with the metal roof panel, and waterproof treatment should be done at the connection between the skylight and the metal roof panel. Moisture prevention, especially in the rainy season, always gives people a feeling of humidity and warmth. It is necessary to prevent water vapor from condensing on the bottom layer of the metal roof and the metal roof layer, and drain the water vapor in the metal roof layer. The solution is to fill the metal roof layer with thermal insulation cotton, lay a waterproof membrane on the metal roof bottom plate, and set up ventilation nodes on the metal roof plate. There are many thunderstorms in summer, so in the design, it is necessary to lead the lightning to the ground to prevent the lightning from penetrating the metal roof and entering the room. Fire is a major hidden danger in the use of steel structure workshops. When a fire occurs in a steel structure workshop, the metal roof material will not burn, and the flame will not penetrate the metal roof panel. The anti-seepage and anti-leakage steel structure workshop must prevent rainwater from seeping into the metal roof panel. Rainwater mainly enters the metal roof through overlapping gaps or nodes. Therefore, it is necessary to use a concealed fixation after using a sealing washer at the screw port, and use a sealant or welding treatment on the lap joint of the board. . Most of the steel structure workshops with general sound insulation are used in production workshops. In the production and construction process, it is inevitable that noise will be generated. In order to prevent the sound from being transmitted from outdoor to indoor or from indoor to outdoor, the steel structure workshop. Fill the metal roof layer with sound insulation material (usually served by thermal insulation cotton). The sound insulation effect is related to the density and thickness of the sound insulation material. Insulation and cooling, hot in summer and freezing in winter, no one likes such a working environment. Therefore, the heat transfer on the metal roof of the steel structure workshop is prevented, and the indoor temperature is stabilized. Covering the surface of the steel structure factory with thermal insulation cotton can generally reduce the indoor temperature by 5-8 °C, or spray high-efficiency heat-insulating reflective paint on the roof panel. The maximum temperature difference on the surface of the plate can reach 20℃, and the indoor temperature difference can reach 8-10℃.