How to install the prefab house to make it more solid

In the construction of prefabricated houses, safety precautions and precautions should be taken to make the prefabricated houses more solid. In fact, not only prefab houses, but also any construction site must take safety precautions. Let's see how to do it well. It needs to be executed strictly according to the construction plan.

The first thing to note is that any screws or related parts cannot be disassembled at will, because such a mobile room is connected by different parts, if removed, it will affect the Stability and performance of mobile chambers. Including the need to pay attention to the construction of drainage ditches to avoid the occurrence of stagnant water. In addition, if you want to live in a prefab house, it is impossible to use an open fire indoors, especially the stove and other indoors. It is necessary to regularly remove rust and paint some parts that are relatively easy to corrode, so as to do the corresponding maintenance work. Extend the service life of the mobile home and avoid affecting its service life. Including the carrying capacity of the mobile room itself is limited, so when using it, you must understand the carrying standard in advance to complete the use.

Here are a few points worth noting to make the prefab house stronger:

1. The panels should be installed smoothly, the eaves should be straight, and the overlapping direction of the panels should be correct and consistent.

2 The circuit of the prefab house should be covered with PVC pipes (slots), the wiring is neat and beautiful, the electrical structure meets the design requirements, there is no insulation aging, and the service life is long.

3. The enclosure panels (roof panels and wall panels) of the prefab house should not have obvious deformation and damage; fixing bolts, waterproof washers, metal washers, nylon sleeves must be complete and reliable, and the sealant must be complete and effective.

4. Lightning protection: The lightning protection grounding device meets the design and specification requirements, and the grounding resistance should meet the standard.

5. Anti-corrosion: steel components should be painted well, without corrosion, and properly protected with exposed bolts; anti-corrosion measures in strong corrosive environments should meet design requirements; Unobstructed drainage, no stagnant water, no debris.

6. The attached siding should be arranged correctly to make the surface of the siding smooth; The length must not be less than 15 mm.