How to prevent leakage of container house

Container house is a kind of mobile house. This kind of container house is mainly rented to the workers at the construction site, and there are also some cases of private purchase and rental. The advantage of container houses is that they are cheap. So, how can the container house prevent leakage?

1. Leak-proof design of container houses

1. When designing the rainwater system for container houses The overflow measures are not set up in accordance with the requirements of the specification, so after the rainwater exceeds the discharge capacity of the system, the rainwater may overflow through the lap joints, resulting in the leakage of the container house surface. Among them, the roof connected with the concealed buckle and the nailing board is very likely to have serious water leakage.

2. The detail parts such as the wrapping of the upper and lower cornices of the window, the flashing board of the roof and the yin and yang corners lack detailed design drawings, resulting in the inexperienced construction team unable to carry out strict construction. This creates a water leak hazard.

3. The purlin of the container house has the design defects of too small section and too large spacing. Therefore, under the action of wind load, the deformation of the purlin and the profiled plate is too large, resulting in Structural defects, resulting in water accumulation on the roof.

2. Leak-proof of container house in construction

1. Gutter welding quality However, if the anti-corrosion treatment of the material is not in place, or the insulation measures under the gutter are not done well, it will cause leakage of the gutter. At the same time, the temperature difference in summer is relatively large, which is prone to condensation.

2. The purlins on the wall of the container house are not straight, there is a gap between the same window frame, or there is a problem with the sealing between the lower opening of the window and the steel structure, and between the window glass and the same profile, As a result, water seepage occurs in the flashing edge trim of the upper window, and water is stored under the eaves of the window.

3. The key nodes of the container house construction are not constructed according to the specified requirements or are not properly handled, such as the short side of the coil is not tightly sealed, the fixing points are scarce, and the mouth is white The iron sheet is deformed, the sealing material is not well sealed, and the inner corner of the root such as the wall is not made into a circular arc or the arc is too small, which leads to the leakage of the roof.

Lida Group is one of the most-trusted manufacturing suppliers to the domestic markets.

Lida Group has had manufacturing experience for over prefab homes years. She currently runs a website where they sell . You can visit her site at Lida Group.

Overall, prefab houses may be a great way for manufacturers to expand their use of technology, but the price could present a significant hurdle for some businesses.