How to reinforce the inclined top prefab?

How to reinforce the sloping roof prefab? Let's take a look at the editor of the light steel prefab. First of all, when building a prefab house with a sloping roof, when purchasing materials such as panel house steel frame, colored steel plate, etc., the material of the real manufacturer must be used, and the use of inferior materials is strictly prohibited.

The sloping roof prefab frame is reinforced by welding two corner pieces with expansion bolts inside and outside the base of each column of steel frames. The light steel prefab house editor tells you to install beams, for single beams, welding studs must be added between the girder beams and the girder beams, and the support strips between the welding studs are cross-shaped, so that when the house encounters strong winds , please ensure the connection between the beam and the beam. Overall, the overall wind resistance is strong.

Each indoor column is equipped with a C-shaped steel wind-resistant column. After installing the partition wall, the editor of the light steel prefab suggested that the spacing of the colored steel plates must be less than 30 cm. There is a connection location that can be pulled by the rivet. , After the partition is completed with rivets and windproof columns, it has the characteristics of strong load-bearing capacity and strong wind.

If the sloping roof prefab is two or three storeys, it must be equipped with 50-shaped round steel pipes to enclose the roof around the prefab. According to the editor of the light steel prefab, the shape of the shell structure is a square grid. The intersection point of the square tube must be fixed. After the steel pipe is fixed on the roof of the board house, the building boards and steel pipe can be placed on the board for fixing. This will effectively ensure the safety of the house.