The prefab house manufacturers remind you how to install the prefab house

In order to better seek higher profits, some manufacturers have kept the profits after contracting the business at a low price. Regardless of the quality of the products they promised, they failed to implement a good supervision system, cut corners, and set up sloppy products, which led to the use of prefab houses. There are serious safety hazards in product quality. Therefore, the following points must be paid special attention to during the installation of the prefabricated house to make the prefabricated house stronger. Now, the manufacturer of the prefab house on the construction site will bring you relevant introductions, hoping to help you.

1. Fire resistance: The fire separation distance should meet the planning and standard requirements, and the fire passage should be clear; the fire hydrant and fire extinguisher equipment should meet the planning requirements, and the layout should be reasonable; The oxygen index of the core board is not less than 32, and the combustible materials such as wooden floors should be treated with fire prevention.

2. The panels of the movable panel house should be installed smoothly, the cornices should be straight, and the overlapping direction of the panels should be correct and consistent.

3. PVC pipes (slots) should be used for the electrical wiring in the prefab house, and the wiring should be neat and beautiful; the electrical equipment should meet the planning requirements; .

Fourth, the prefab house enclosure panels (roof and wall panels) should be free from obvious deformation and damage; fixing bolts, waterproof washers, metal washers, nylon sleeves, etc. , the connection is reliable; the sealant is completely effective.

5. Lightning protection: lightning protection grounding setting conforms to planning and standard requirements; grounding resistance should be tested and qualified.

Six, anti-corrosion: steel components should be painted without defects, no rust, and exposed bolts should be properly protected; the anti-corrosion measures in strong corrosive environments meet the planning requirements; the surrounding area of u200bu200bthe movable room should be well drained , No stagnant water, no sundries.

Seven, the attached wall panel device should be arranged correctly and the surface should be flat; Lap down, the lap length is not less than 15mm.

The above is the relevant content brought by the manufacturer of prefabricated houses. If you have any questions, please call. Thanks for reading.